Winchester M1 Garand
Winchester M1 Garand
Hover to zoom, click for larger images

Winchester M1 Garand

Price: $1,400.00
Out of Stock.
Item Number:FW01300

Winchester M1 Garand serial number 2524xxx, manufactured December 1944. This M1 has a 1951 Springfield barrel with a bright bore. Other parts are mostly Springfield, all are described below and shown in photos. No import marks.

This M1 is in excellent used condition. It has a new walnut stock with a nice darker finish. New repro canvas sling and two M1 enbloc clips (no ammo) are included.

We test fired this Garand and it performed well, cycling through a full clip, ejecting the clip at the end. 




Receiver: marked “D28291-2” on leg. Misc. assembly markings on several surfaces underneath. Excellent condition, absolutely no pitting. Has been refinished. Lettering and serial number are sharp; even the tiny “TRADEMARK” lettering is readable. Receiver legs have rough machining marks, typical for Winchester.

Barrel: marked “S-A-5-51” in op rod slot with proof mark “P” and punch mark. Also marked “D35448 41 A147A” on top, with small stars and eagle stamp. The bore is bright and shiny, rifling is sharp. No external pitting, good finish with some wear on the exposed front section.

Barrel Gauge Readings: Muzzle Erosion (ME): 1 ½, Throat Erosion (TE):  3

Op rod: curved side, marked “D35382 6 SA”, modified. Good working condition, has some surface pitting just behind the gas piston.

Op rod catch: late type, unmarked

Bullet guide: stamped type without notch

Clip latch: early round front type, unmarked

Follower: late type, unmarked

Follower arm: no bevel

Follower rod: long fork, riveted

Bolt: marked “D28287-12 SA S-06<>”, good condition with most of its finish. Firing pin unmarked, extractor marked “PB”.

Sight knobs: T105 postwar type, elevation marked “NHC”, windage “DRC”.

Rear sight cover: late type with ribs

Rear sight aperture: double track

Trigger housing: marked “D28290-14-SA”, small pad, cloverleaf hole. Good condition, finish a little spotty inside.

Trigger guard: stamped with milled hook

Trigger: late type, no extra hole

Hammer spring plunger: late type without wings

Hammer: marked “SA D5546008”

Safety: round top, marked “WCS”, a commercially manufactured replacement, works fine

Gas cylinder: wide sight platform, flat on top of rear ring. Gas cylinder group has been refinished.

Front sight: 0.67 wide

Gas cylinder lock: WWII beveled front type, unmarked

Gas cylinder lock screw: cross slot poppet valve type, marked “T PAX”

Stock and handguards: new, walnut, nice finish

Sling: new repro




Related Items


M1 Garand Fleece Lined Case Reproduction US
$39.99  $29.95
In Stock.
M1 Garand Leather Sling Reproduction 1907
$29.95  $19.95
In Stock.

Recently Viewed Items