Springfield Armory M1D Garand serial number 3819772 with USGI
M84 scope and mount. Receiver was made in June 1945, barrel date is July 1951. This
M1D came from the CMP as a M1D Service grade complete package. It includes a CMP
certificate of authenticity. Everything
on this rifle is USGI. No import marks.
This M1D is in excellent used condition, and appears
unused since built as M1D, other than our test firing. It operates perfectly,
cycling through a full eight round clip, ejecting the clip at the end.
Two M1 enbloc clips (no ammo) along with the sling and
accessories noted below are included. This rifle will ship in a foam lined hard CMP case.
Receiver: marked “D 28291 35” on leg, heat lot 090B. Leg
also hand engraved “TE 12-68”. Excellent condition, no pitting. Finish (not
original) shows very little wear.
Barrel: marked “S-A-7-51” in op rod slot, also marked “P”
with punch mark. Bore is bright like new, rifling and crown excellent. External
finish is in excellent condition. The lack of an op rod “rub” on the barrel,
other than our test firing, indicates very little use since this rifle was
built as M1D.
Barrel Gauge Measurements: Muzzle Wear: 1 1/4 Throat Erosion: 3 1/4 (Want to learn more about these measurements? Read our Barrel Erosion Guide.)
Scope: marked “TELESCOPE M84 SERIAL NO. 36654”. Complete
with rubber eyepiece and objective shield. Adjustment turret base marked
“7667424”. Crosshair (post type) sharp and complete. No dents, external finish
very good, no pitting. Turret caps dented but complete, working. Manufacturer Libby
Owens Ford, note white border around serial number.
Scope mount: GI, very good condition
Lower band: 2-piece flat top with roll pin
Clip latch: WWII round front
Op rod: flat side, marked “D35382 SA. Exc condition, no
pitting, little finish wear
Op rod catch: late type, marked “B”, Harvester part
Bullet guide: stamped without notch
Follower: late type marked “11”
Follower arm: no bevel
Follower rod: long fork, riveted
Bolt: marked “6528287-SA A15”
Sight knobs: postwar T105 type, windage marked “LUX”,
elevation marked “DRC”, very light stamp
Rear sight cover: late type with ribs
Rear sight aperture: double track, unmarked
marked “6528290 – HRA N”, very light stamp. Excellent condition, no
pitting, some finish wear
Trigger guard: WWII milled SA
Trigger: late type, no extra hole
Hammer: marked “C46008-7 SA”
Hammer spring plunger: late type without wings
Gas cylinder: wide sight platform, flat on top of rear ring
marked “E”, punch on bayonet lug. Gas cylinder group finish in fair condition
Front sight: 0.85 wide, unmarked.
Gas cylinder lock: beveled front, unmarked
Gas cylinder screw: cross slot poppet valve type, marked
“P” with hexagon
Stock: walnut, apparently arsenal replacement. No markings
other than “H” on pistol grip. No cracks, about average dings/scratches, worst
scratch on pistol grip, still nice appearance overall
Cheekpad: leather, no date marking”. Not attached with
screws, and no visible screw holes in the wood.
Handguards: walnut, no cracks, about same condition as
Buttplate: round plunger, good condition with some finish
Accessories: sealed bag containing canvas scope cover,
probably nothing else