1. Home
  2. Used and Collectibles
  3. Military Surplus
  4. M1 Garand
  5. Springfield Armory M1 Garand with 1955 Barrel
Click Large Image for Full Gallery
Springfield Armory M1 Garand  with 1955 Barrel
Springfield Armory M1 Garand

Springfield Armory M1 Garand with 1955 Barrel

Price: $1,500.00
Early WWII receiver
Item Number: FW01324
Availability: SOLD.

Springfield Armory M1 Garand, serial number 1506xxx. Early WWII receiver manufactured April 1943, barrel is 1955 Springfield.  Walnut stock. No import marks.

This M1 is in excellent used condition. Parts are mostly Springfield, some postwar, all are described below and shown in pictures.

This Garand has been disassembled, cleaned, lubricated, and test fired. Parts were clean for photos, coated with oil and greased where appropriate when reassembled.

Two M1 enbloc clips (no ammo) and repro sling are included.




Receiver: marked “D 28291 27” on leg, heat lot M6. Excellent condition, no pitting. Finish is fairly good with some wear, not original.

Barrel: marked “SA F6535448 5 55 MD 50” in op rod slot, with a couple “P” marks, “O”, “T”, punch, and small stars and eagle stamp. Bore is bright like new, exc crown and rifling. Condition of external finish and gas port shows very little firing since installed.

Barrel Gauge Measurements: Muzzle Wear: 3/4  Throat Erosion:   (Want to learn more about these measurements? Read our Barrel Erosion Guide.)

Clip latch: WWII round front

Op rod: curved side, marked “D35832 9 SA” – the “D3”  is missing because the rod is modified. VG condition, no pitting, some finish wear

Op rod catch: late type, unmarked

Bullet guide: stamped with notch

Follower: late type, marked “11”

Follower arm: no bevel

Follower rod: long fork, riveted

Bolt: marked “6528287-SA A11”

Sight knob markings: both marked “WCE”

Rear sight cover: late type with ribs

Rear sight aperture: double track

Trigger housing:  marked “D28290-14-SA”. No pitting, a little finish wear

Trigger guard: stamped with stamped hook

Trigger: late type, no extra hole

Hammer: marked “SA D5546008”

Hammer spring plunger: late type without wings

Safety: round top, unmarked

Gas cylinder: wide sight platform, flat on top of rear ring. Gas cylinder group is refinished.

Front sight: 0.75 wide

Gas cylinder lock: postwar “high hump”

Gas cylinder screw: cross slot, poppet valve type, marked “P” and “+”

Stock and handguards: Commercial, walnut, almost new condition, a few small handling marks

Sling: new repro



Recently Viewed Items