1. Home
  2. New to Our Store
  3. HRA M1 Garand H & R Arms
Click Large Image for Full Gallery
HRA M1 Garand H & R Arms
HRA M1 Garand

HRA M1 Garand H & R Arms

Price: $1,400.00
1954 Production with Springfield Barrel
Item Number: FW01331
Availability: In Stock.

Harrington & Richardson M1 Garand, serial number 47300xx, manufactured about 1954. This M1 has a Springfield 1952 barrel with bright bore. All parts but receiver and bolt are Springfield, all are described below and shown in photos. No import marks. Stock is new walnut.

The rifle has been disassembled, cleaned, lubricated, and test fired. Parts were clean for photos, coated with oil and greased where appropriate when reassembled.

Two M1 enbloc clips (no ammo) and repro sling are included.

 

Specs:

 

Receiver: marked “D-6528291” on leg, heat lot A. Excellent condition, no pitting, has new finish.

Barrel: marked “S-A-3-52” in op rod slot, with “P”, also marked on top “D6535448 45 A167A”, “M”, and small crossed cannons stamp. Bore is bright, very good crown and rifling. Chrome pads at gas port.

Barrel Gauge Measurements: Muzzle Wear: 1 ½, Throat Erosion: 2 1/2   (Want to learn more about these measurements? Read our Barrel Erosion Guide.)

Barrel band: two-piece flat top with roll pin

Clip latch: late square front type.

Op rod: flat side, marked “6535382 SA”. No pitting, new finish

Op rod catch: late type, unmarked

Bullet guide: milled WWII type

Follower: late type, unmarked

Follower arm: no bevel, marked “12”

Follower rod: long fork, riveted

Bolt: marked “D6528287 HRA .U.”

Sight knobs: elevation marked “NHC”, windage “DRC”

Rear sight cover: late type with ribs

Rear sight aperture: double track

Trigger housing:  marked “D28290-12 -SA”

Trigger guard: milled WWII SA

Trigger: late type, no extra hole

Hammer: marked “C46008-3 SA”

Safety: round top, marked “SA”

Gas cylinder: wide sight platform, flat on top of rear ring. Gas cylinder group finish in good condition.

Front sight: .63 wide

Gas cylinder lock: beveled front WWII type

Gas cylinder screw: cross slot, poppet valve type marked “P” with hexagon

Stock and handguards: walnut, commercial reproduction, new condition, may have a few minor handling marks

Accessories: sling, new repro

 


Accessories

M1 Enbloc Clip
$2.50
In Stock.

Recently Viewed Items

TOP