Here is a WWII M1 Garand reborn in a hard to find gray laminate
stock. The receiver is Springfield Armory, six digit serial number 319401, manufactured August
1941. Barrel is LMR, dated October 1952 with a bright bore. No import marks.
This M1 is in excellent used condition. All metal parts have just been
professionally refinished. Marked parts are of mixed manufacture, all are noted
below and shown in photos.
This M1 shoots great, watch our video to see how well it performed at
The gun has been disassembled, cleaned, and lubricated. Parts were
clean for photos, coated with oil and greased where appropriate when
reassembled. Two M1 enbloc clips (no ammo) and sling are included.
C & R Eligible**
Springfield Armory M1 sn 319401
Receiver: marked “U.S. RIFLE
CAL. 30 M1 SPRINGFIELD ARMORY” on heel, “D 28291-12 S A” and “XX” on leg, heat
Barrel: marked “LMR D6535448
10 52 A4” with “P”, “M”, and crossed cannons stamp in op rod slot. Chrome pads
at gas port. Bore is bright and shiny, crown and rifling excellent.
Lower band: two piece flat
top with roll pin
Barrel Gauge Measurements:
Muzzle Wear (MW): 1 ½, Throat Erosion (TE): 2
Clip latch: square front
Op rod: marked “D35382 6 SA.”,
excellent condition. Op rod and bolt cycle freely by tilting when everything is
assembled except main spring and hammer (Garands with binding or rubbing op
rods tend to have feeding and/or ejecting problems).
Op rod catch: HRA/SA/IHC
Bullet guide: stamped with
Follower: late type, unmarked
Follower arm: no bevel, unmarked
Follower rod: long fork,
Bolt: marked “D28287-12 RE5B”
Elevation knob: Weatherhead
Windage knob: marked “IHC
Rear sight base: late SA/HRA
Rear sight aperture: SA/HRA type,
Trigger housing: marked “IHC D6528290”. Small pad, cloverleaf
Trigger guard: stamped with
Trigger: late type, no extra
Hammer: marked “C-5546008
Hammer spring plunger: postwar
type, no wings
Safety: round top, marked
Gas cylinder: wide sight
platform, flat on top of rear ring.
Front sight: 0.65 wide,
Gas cylinder lock: non-beveled
type, marked “M”
Gas cylinder lock screw:
cross slot poppet valve type, marked “HRA” and “O”
Stock and handguards: new
Sling: new reproduction
**Firearms marked “C & R eligible” can be shipped
directly to holders of valid Curio and Relics FFLs. Non licensed individuals
may purchase these guns but they must be shipped to an FFL dealer. More
information available in our How to Buy Guide.