HRA M1 Garand 1955 All H &R sn 56210xx
Hover to zoom, click for larger images

HRA M1 Garand 1955 All H &R sn 56210xx

Your Price: $1,850.00
Out of Stock.
Item Number:FW01183

­HRA M1 Garand 56210xx, made around 1955. HRA 4-55 barrel with a like new bore. All marked parts are HRA, no import marks. HRA stock with stars & eagle and circle “P”, very nice appearance.

 

This M1 rifle is in excellent+ used condition. From the condition of the bolt face, op rod, lower rear barrel section, gas port, and minimal wear in general, it is obvious that this rifle has been fired very little, possibly not since proofed, and has rarely even been hand-cycled.

 

The gun has been disassembled, cleaned, and lubricated. Parts were clean for photos, coated with oil and greased where appropriate when reassembled.

 

Two M1 enbloc clips (no ammo), canvas bandolier and repro canvas sling are included.

 

C & R Eligible**

 

HRA M1 sn 56210xx Specs:

 

 

·         Receiver: marked “6528291” on leg, heat lot “H”. Excellent condition, absolutely no pitting, no finish wear even at corners.

·         Barrel: marked “HRA 6353448 4-55 RS50” in op rod slot, with “P” and punch mark, “M”, and small stars and eagle. Chrome pads at gas port. Bore is bright as new. Crown excellent, chamber in the white. External finish is in exc. condition, no pitting.

·         Lower band: two piece flat top with roll pin

·         Barrel Gauge Measurements: Muzzle Wear (MW): 1, Throat Erosion (TE): 2

·         Clip latch: square front type, unmarked

·         Op rod: marked “6535382 HRA”, excellent condition, slight finish wear on handle tip and at contact points, no pitting. Op rod and bolt cycle freely by tilting when everything is assembled except main spring and hammer (Garands with binding or rubbing op rods tend to have feeding and/or ejecting problems).

·         Op rod catch: HRA/SA/IHC type, unmarked

·         Bullet guide: stamped with notch, unmarked

·         Follower: late type, unmarked

·         Follower arm: no bevel, unmarked

·         Follower rod: long fork, riveted, unmarked

·         Bolt: marked “658287 HRA .U.”

·         Firing pin: half round, no chrome tip, unmarked

·         Elevation knob: marked “HRA”

·         Windage knob: marked “DRC”

·         Rear sight base: late SA/HRA type, unmarked

·         Rear sight aperture: SA/HRA type, double track

·         Trigger housing:  marked “6528290-HRA N”. Small pad, cloverleaf hole, no pitting

·         Trigger guard: stamped with stamped hook

·         Trigger: late type, no extra hole

·         Hammer: marked “HRA 5546008”

·         Hammer spring plunger: postwar type, no wings

·         Safety: round top, marked “HRA”

·         Gas cylinder: wide sight platform, flat on top of rear ring. Gas cylinder group finish is very good, just a few small scratches.

·         Front sight: 0.70 wide, unmarked

·         Gas cylinder lock: postwar high hump type, unmarked

·         Gas cylinder lock screw: cross slot poppet valve type, marked “HRA” and “O”

·         Stock: walnut, clearly HRA from thickness at pistol grip and the “horseshoe”. Circled “P” on pistol grip, 1/2” stars and eagle (DAS) on left side, both markings very sharp. No cracks, far fewer than average dings/scratches, outstanding appearance.

·         Buttplate: round plunger type, exc condition with very little finish wear

·         Stock ferrule: with hole

·         Handguards: walnut, handling marks, same condition and appearance as stock.

 

 

 

Related Items

Recently Viewed Items